You can disable AutoRCM by entering the same menu above and selecting ‘Disable AutoRCM’.įrom now on, to boot into stock firmware, select ‘Launch > Stock’ in Hekate. Select ‘Tools > Archive Bit - AutoRCM > Enable AutoRCM’ Push the Hekate payload to your Switch while holding Vol- to skip autoboot and enter the menu This might sound scary but is not actually dangerous, and can be undone at any time.īy doing this, you will need to use a payload sender to boot your Switch after every restart/shutdown. You can follow this video: IncognitoRCMn n 5.- Choose one of the boot options. Essentially, you are purposefully bricking your Switch in a controlled matter that forces it to launch into recovery. 3b.-For RCM loader like me, delete all inside the device and use RCMLoaderFirmware has the new firmware n 4.- Install Incognito to use the internet safely n. Failure to heed this warning will result in a bricked Switch.ĪutoRCM is an optional software method of forcing your Switch to go into RCM on every launch, without the need of a jig or hardmod. If you cannot run payloads from RCM with fusee-gelee, DO NOT ENABLE AUTORCM. Enabling AutoRCM on an IPATCHED Switch will literally BRICK your Switch. This section is only intended to be used on consoles with a vulnerable RCM. WARNING Never enable AutoRCM on an IPATCHED Switch
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |